Roland VS-1824 Bedienungshandbuch PDF herunterladen (Seite 58)

Chapter 4 Recording Operations

3. Using [ ], [ ], [ ], and [ ], select “Foot

Sw.” If “Foot Sw” does not appear in the display, press

[F2 (Prm 2)].

fig.03-10

FootSw (Foot Switch)

Set the function of the foot switch connected to the FOOT

SWITCH jack. You may select one of the following functions.

Play/Stop:

Alternates between playing back and stopping each time

the foot switch is pressed.

Record:

The same function as [REC]. Use this for performing

punch-ins and punch-outs with a foot switch.

TapMarker:

The same function as [TAP]. Press the foot switch to

place a marker at the current position of the time line.

Performs the same function as [NEXT]. Moves the time

line to the beginning or end of the next phrase each time

the foot switch is pressed.

Performs the same function as [PREVIOUS]. Moves the

time line to the beginning or end of the previous phrase

each time the foot switch is pressed.

GPI:

Controls playback and recording depending on the GPI

trigger signal received from the FOOT SWITCH jack.

GPI (See Appendices p. 12)

4. Select “Record” with the TIME/VALUE dial.

5. Press [PLAY (DISPLAY)] to return to the Playlist display.

Now you can punch in and punch out of record using the

foot switch. Follow the same steps as if you were going to

perform a manual punch-in (p. 57), but use the foot switch

instead of the [REC] button to perform the operations in

Steps 9 to 11.

Auto Punch-In and Punch-Out

You can automatically punch in and punch out at pre-

programmed locations. This process is called an auto punch-

in. This is convenient when you need to punch in or out at a

precise time. Before you begin recording, set the times for

punch-in and punch-out. There are three ways to set these

times as described below. Use the method appropriate for

your situation.

Using Locators

1. Find the position in the song where you want to punch

in. Place a locator at that point. Find the position in the

song where you want to punch out. Place another locator

there.

2. While holding down [AUTO PUNCH], press the locator

corresponding to the punch-in point.

3. While continuing to hold [AUTO PUNCH], press the

locator corresponding to the punch-out point.

fig.03-12

Using Markers

fig.03-13

1. Place two markers, one at the desired punch-in point,

and one at the desired punch-out point.

2. Move to the marker which corresponds with the punch-

in point.

3. Hold [AUTO PUNCH], and press [NEXT].

4. Without releasing [AUTO PUNCH], press [PREVIOUS].

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 294 295

Kommentare zu diesen Handbüchern

Keine Kommentare

Roland VS-1824 Bedienungshandbuch Seite 58

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Musikinstrumente Roland VS-1824