Roland VS-1824 Bedienungshandbuch PDF herunterladen (Seite 100)

100

Chapter 7 Using Internal Effects (VS8F-2)

Loop Effects

With loop effects, the original sound and the effected sound

are mixed together. Effects such as reverbs and delays are

typically connected using a loop.

fig.05-07

In a loop effect, the original signal is copied and sent to the

effect. Later in the signal flow, the output of the effect

processor is mixed back in with the original signal. A loop

effect provides independent control of the original signal

(using the channel fader) and the Effect Return Level. All 28

channels of the VS-1824s mixer can be routed to a single

effect using a loop effect. For example, you can have up to 28

different mixer channels routed to the same reverb, with

different send levels on each channel.

A mixer channel can be connected to a loop effect using

either of two different switch positions. These are referred to

as “pre-fader” and “post-fader.”

Pre Fader

With the effect switch set to Pre Fader, the signal is sent to

the effect before it passes through its channel fader. The

position of the channel fader has no affect on the amount of

signal going to the effect. The signal is sent to the effect at the

level set with the Effect Send Level value.

Post Fader

With the effect switch set to Post Fader, the signal is sent to

the effect after it passes through the channel fader. The

position of the channel fader has a direct bearing on the

amount of signal going to the effect. As the channel fader is

lowered, the amount of signal going to the effect is lowered.

As the channel fader is raised, the amount of signal going to

the effect is raised. As a result, the direct signal and the

effected signal always stay in proportion.

Making the Effect Connection

The VS-1824 Channel Mixer display provides two different

areas for connecting effects. One area is used for connecting

insert effects only, and is labeled “FXIns.” The other area is

used for connecting loop effects. This area appears at the

bottom of the Mixer screen, and is labeled “FX1”, “FX2”,

“FX3”, and “FX4.” To find out if an effect should be

connected as an insert or as a loop, see “Preset Patch List”

(Appendices p. 20). Look under “Type.” The Type of effect

determines which area of the Mixer display should be used

to connect it.

Procedure for Using Effects

To use an effect in the VS-1824, follow these three general

steps:

1. Select the Effect Patch to use.

2. Determine whether the effect should be used as an insert

effect or in a loop effect.

3. Connect the effect within the mixer. The exact methods

for each of these three steps are explained below.

Level

(Fader)

(2band, 3band)

FX1

Send

Level

Pan

FX2

Send

Level

Pan

FX3

Send

Level

Pan

FX4

Send

Level

Pan

AUX

Send

Level

Pan

FX1

FX2

FX3

FX4

MIX bus or REC bus

AUX bus

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 294 295

Kommentare zu diesen Handbüchern

Keine Kommentare

Roland VS-1824 Bedienungshandbuch Seite 100

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Musikinstrumente Roland VS-1824