Roland VS-2000 Betriebsanweisung PDF herunterladen (Seite 143)

143

Chapter 10 Track and Phrase Editing

Chapter 10

If you are unhappy with the edit you made, press [UNDO].

“UNDO Level 1” will be displayed. Press [YES] to restore

your track(s) to their condition prior to the edit.

Track Copy

This operation copies audio to another location on the

timeline, and simultaneously, to another playback track, if

desired. This is convenient when you want the same chorus

to occur at several different points of the song, but you don’t

want to re-record it each time.

fig.04-02

1. Hold [SHIFT] and press [F2 (TRACK)].

2. Make sure “Track Edit Menu” appears in the display. If it

does not, press [F1 (Tr/Ph)] once.

3. Press [F2 (Copy)] for Track Copy. If you don’t see

“Copy” above [F2], press [PAGE] until “Copy” appears,

and then press [F2 (Copy)].

4. The track [SELECT] buttons are used to select the source

track(s) and the [STATUS] buttons are used to select the

destination track(s). Press the Track SELECT button to

specify the track to be copied. The SELECT button stops

blinking, indicating it is the track to be copied. Press the

Track STATUS button for the desired destination track.

The STATUS button turns red. For example, if you

wanted to copy the section of audio from Track 3 to

Track 7, you would first press the Track 3 SELECT

button, then press Track 7 STATUS.

Alternate method:

a. Press [F1 (SelTr)].

b. Press [ ], [ ], [ ], and [ ] to move the

cursor to the track you want to copy.

c. Press [F3 (MARK)].

If you would like to copy entire sections of your song, you

can press [F2 (All)] to select all tracks for copying.

fig.04-03

e. Use the TIME/VALUE dial to specify the V-Track

for the destination. For example, “1-1” indicates

“Track 1, V-Track 1,” and “9L-1” indicates “Track 9,

V-Track 1.”

* Do not designate V-Tracks that have already been specified as

copy destinations for other tracks.

Press [F1 (Back)].

5. Press [ ], [ ], [ ], and [ ] to move the

cursor. Set the START, END, FROM, and TO values.

A quick way to enter edit points (START, END, FROM, and

TO) is to create a locator for each edit point (p. 45) before

entering the edit screen. Then go to the desired edit screen

(such as Erase, Copy, Cut). You can enter your edit points by

pressing a LOCATOR button and then holding [SHIFT] and

pressing [LOC 1] to enter that point as the START time, [LOC

2] to enter that point as the END time, [LOC 3] to enter that

point as the FROM time, or [LOC 4] to enter that point as the

TO time.

AA'A"

Start End To Time

B' B"

Start End To Time

Example 1: Copying twice to the same track

Example 2: Copying twice to a different track

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 281 282

Kommentare zu diesen Handbüchern

Keine Kommentare

Roland VS-2000 Betriebsanweisung Seite 143

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Musikinstrumente Roland VS-2000