Roland VS-1680 Bedienungshandbuch PDF herunterladen (Seite 108)

Adjusting the Balance of the Overall

Effect Send Level

You can adjust the balance of the total effect send level

for each effect with the effect send level (p. 107) and

pan (p. 107) settings that are assigned to each individ-

ual channel left as they are.

1. Press [MASTER].

2. Press [F1 (EFX1)]. If “EFX1” does not appear in

[F1], first press [PAGE] until “EFX1” is displayed,

then press [F1 (EFX1)]. Alternatively, use [ ],

[ ], [ ], and [ ] to move the cursor to

“EFX1.”

3. Use [ ], [ ], [ ], and [ ] to move the

cursor. Rotate the TIME/VALUE dial.

fig.05-10(mastersnd.eps)

(Send Level)

This adjusts the total volume level of the signal (-42–6

dB) sent to the effect. Set the initial value to “100.”

(Balance)

This adjusts the balance (L63–0–R63) of the total signal

sent to the effect. Set the initial value to “0” (center).

* You can adjust the overall send level and balance for

EFX2–EFX4 in the same manner.

Selecting Effects (Patch)

An effect settings is referred to as a patch. The VS-

1680 provides 210 (P000-P209) read-only effects (Preset

Patches) and 200 (U000-U199) read and write effects

(User Patches). Please take a moment to check these

effects.

* If used in combination with the Vari Pitch function (p.

166), delay times may change somewhat, and for distor-

tion effects (distortion, overdrive, etc.), there may be some

change in the quality of the tone.

* With some of the effects, you may not want the direct

sound output, or other special setting may be required.

Please refer to “Algorithm List” (Appendices p. 81) when

making these settings.

1. Press [PLAY (DISPLAY)].

2. When you wish to use EFX1/EFX2, hold down

[SHIFT] and press [F3 (EFFECT A)]. When you

wish to use EFX3/EFX4, hold down [SHIFT] and

press [F4 (EFFECT B)].

3. Press [F1 (EFX1)].

The Effects 1 settings screen appears in the display.

4. Press [F2 (Sel)].

The effects list appears in the display.

5. Use the TIME/VALUE dial to move the cursor to

the effect you wish to use.

Send Level

Send Balance

If “No Effect Board” Appears in the

Display

This indicates there is no VS8F-2 installed. In this

case, you cannot use the internal effects.

If the message appears even when a VS8F-2 is

installed, it indicates that the effect expansion

board is not being recognized properly. Perform

the shutdown procedure and turn the power off

as described in “Turning Off the Power” (p. 32),

then reinstall the VS8F-2 correctly.

Chapter 5 Using the Internal Effects (VS8F-2)

108

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 211 212

Kommentare zu diesen Handbüchern

Keine Kommentare

Roland VS-1680 Bedienungshandbuch Seite 108

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Musikinstrumente Roland VS-1680