Roland XC-540MT Bedienungsanleitung PDF herunterladen (Seite 43)

Chapter 2 Basic Operation

2-4 Starting Output

Getting Ready to Receive Data from a Computer

When you have nished loading media and making the temperature settings for the media heating

system, then follow the steps below. This procedure enables the machine to receive data from the

computer and perform output.

Note, however, that when you want to perform only cutting, operation that diers from the following

procedure is required.

 P. 50, "To Perform Cutting"

Procedure



Close the front cover.



Press (making the light come on).



Wait until stops ashing and stays steadily lit.



Make sure you are at the top menu.

If you are not at the top menu, press , then press .

Output Is Not Possible in These Situations

○The machine does not run when the front cover is open. Also, never open it when output is in prog-

ress. Doing so interrupts output.

○Data from the computer is not accepted when is dark.

○Printing does not start until lights up.

○Data from the computer is not accepted when you are not at the top menu.

Points Which Must Be Observed

○Be sure to set the media clamps during printing. Otherwise the edges of the media may warp and

catch on the print heads.

○During output, never touch the media that's already been discharged. Doing so may obstruct media

feed or cause the media to rub against the heads, which may result in a paper jam or damage to

the heads.

Top screen

Steadily lighted

Flashing→Steadily lighted

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 171 172

Keine Kommentare

Roland XC-540MT Bedienungsanleitung Seite 43