Roland VS-880EX Bedienungshandbuch PDF herunterladen (Seite 46)

VS-880EX Application Guide

There are many times that you may want to record a track”dry,” (without any effects), but you might want

to listen to effects during the recording. A typical example is listening to reverb on your guitar while you

are recording it, but not recording the reverb on the guitar track. By listening to the effects during

recording, you can begin to think about what you might use for effects during the mixdown. However,

since the track is “dry” (no recorded effects), you will be able to wait until mixdown to make your final

effects decisions. The example uses the VS-880EX’s built-in effects.

You will connect your guitar to the VS-880EX, select an effect to listen to, select a track to record to, and

then record the guitar ‘dry’ to the VS-880EX.

ACTION: Recording A Guitar ‘Dry’ While Listening

With Internal Effects

1. Press the [FADER/EDIT] button until it lights orange.

2. Plug your Guitar into Input #2 on the rear of the VS-880EX (1/4” phone jack).

3. Play the guitar as loud as you will during the performance and turn the [INPUT SENS 2]

knob clockwise until the PEAK light turns red, then turn it slightly counterclockwise until

the red peak LED goes off. (The read peak LED should only come on occasionally during the

loudest point of your performance.)

4. Hold the [STATUS] button 2 and press the [CH EDIT 2] button until it is flashing orange.

5. Press the [STATUS] button 2 until it flashes red. This sets track two to record ready mode.

6. Raise the [FADER] on channel 2 to monitor the guitar.

7. Press the [CH EDIT 2] button to select Channel 2 for editing.

8. Hold [SHIFT] and press the [EFFECT 2] (CH EDIT 8) button. Use the TIME/VALUE dial to

select “OFF.”

9. Press the [FADER/EDIT] button until it lights green.

10. Hold [SHIFT] and press the [EFFECT 1] (CH EDIT 7) button.

11. Press the [<<PARAMETER] button and use the TIME/VALUE dial to select “TR2 FX1 Ins =

Insert.”

12. Press the [EFFECT] button under EDIT CONDITION repeatedly until you see “EFFECT-1

PRM?”

13. Press the [YES] button.

14. Use the TIME/VALUE dial to select the effect you want to hear, then press the [YES] button.

15. After you choose the effect you want to listen to during the recording, press the [PLAY

(DISPLAY)] button.

16. Press the [ZERO] button to return to the beginning of your song.

17. Press the [REC] and [PLAY] buttons to begin recording.

Recording A Guitar ‘Dry’ While Listening With Effects

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 145 146

Keine Kommentare

Roland VS-880EX Bedienungshandbuch Seite 46