Roland PNC-950 Bedienungsanleitung PDF herunterladen (Seite 18)

• About the Cutting Area

About 1 mm (about 0.04")

24,998 mm

(984-1/8")

Cutting coordinate

origin (0,0)

About 15 mm (about 9/16")

Movable Pinch Roller (Left)

Cutting area

Movable Pinch Roller (Right)

584 mm (22-15/16")

4-5 Setting the Origin Point — , , , , ORIGIN SET Keys

The PNC-950 allows the origin point (0,0) to be set at any position in the cutting area.

When loading a rolled sheet set DIP switch SW-9 to OFF. Once the sheet is loaded and the SETUP key has been pressed,

the origin (0,0) is automatically set to a position near the left movable pinch roller on the left-hand side. When the

ROTATE key has been pressed to turn on the Rotate function and make the ROTATE LED light up, the origin is set to a

position near the movable pinch roller on the right-hand side.

When loading a flat sheet DIP switch SW-9 should be ON. Once the sheet is loaded and the SETUP key has been

pressed, the unit will scan and calculate the sheet's size, the origin (0,0) will be automatically set to the sheet's front left

edge.

If there is no need to move the origin initially set, then it is not necessary to make the origin point setting immediately

after loading a sheet.

You can also set the origin to an uncut area of a sheet in order to use the sheet with maximum effectiveness.

Procedure

* If a sheet has not yet been loaded, then before setting the origin point, refer to "Loading the Sheet" on page

7 to load the sheet correctly. Loading a sheet after the origin has been set (by pressing the SETUP key to

extinguish the SETUP LED) cancels the origin that has been set.

(1) Use the , , , and keys to move the tool

carriage to the position on the sheet where the origin

point is to be set.

The SETUP LED flashes once

The origin point has been set

ORIGIN SET

→

(2) Press the ORIGIN SET key.

* The arrows in the figure indicating

the X and Y directions indicate

respectively the positive directions

of the X axis and Y axis when the

Rotate function is off.

When use the sheet guide

Maximum cutting area: 558 mm (21-15/16") (horizontal direction) x 24,998 mm (984-1/8") (vertical direction)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Keine Kommentare

Roland PNC-950 Bedienungsanleitung Seite 18