Roland Metaza MPX-80 Bedienungsanleitung PDF herunterladen (Seite 97)

Chapter 5 Maintenance and Adjustment

5-4 Adjustment of the Origin-point Location

Adjusting the Location of the Machine's Origin Point

The origin point of the machine must be the center of the scale on the table. You can check the origin-point

location by printing calibration data. Adjust the origin point if it is displaced.

Prepare a plate-shaped material larger than 20 millimeters square.

Print calibration data.



Switch on the power to the machine.

 P. 30, "Switching On the Power"



Mount material.

Set material using the adhesive sheet and table.

Be sure to use the head cap.

 P. 36, "Loading Material Using the Adhesive Sheet"



Start METAZAStudio.

 P. 44, "Starting METAZAStudio"



Click .

For [Look in], select the [Sam-

ples] folder in the [METAZAStudio]

folder*.

* The folder where METAZAStudio is

installed

Select [Axis.mzs]

Click [Open].



Start printing.

 P. 52, "Starting Printing"

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 119 120

Keine Kommentare

Roland Metaza MPX-80 Bedienungsanleitung Seite 97