Roland Metaza MPX-80 Bedienungsanleitung PDF herunterladen (Seite 60)

Chapter 4 More Advanced Operations

4-4 Creating Data for Printing on a Curved Surface

With this machine, using a head cap lets you perform printing on cylinders and other examples of material whose

surface height is not uniform.

This section describes how to create data, using printing on a cylindrical material like the one shown below as an

example.

Step1 : Decide on the Printing Area (Workpiece Size)

First, you make the settings for the printing area on the material. In the case of printing on cylindrical material, printing

over the entire surface of the material (as on flat material) is not possible. For this reason, the METAZAStudio editing

window displays the printing area instead of the material. The printing area is determined by the value of the material’s

diameter entered at the setting window for the driver.

For more information about the conditions of cylindrical material that this machine can print, refer to the page indi-

cated below.

☞ P. 29, "Conditions for Printable Cylindrical Material"

Procedure

➊

Set the margins to 0 millimeters.

Click [File], then click [Preferences].

The [Preferences] dialog box appears.

Set “Margin” to “0 mm.”

Click [OK].

Important !

When you’re printing on cylindrical material, set the margins to zero millimeters. When printing on cylindrical mate-

rial, the markable area is limited, and so a sufficient printing area must be ensured by making the margins zero

millimeters in size.

50mm

10mm

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 95 96

Keine Kommentare

Roland Metaza MPX-80 Bedienungsanleitung Seite 60