Roland Metaza MPX-80 Bedienungsanleitung PDF herunterladen (Seite 33)

Chapter 3 Performing Printing

3-4 Loading Material (Using the Adhesive Sheet)

Loading Material Using the Adhesive Sheet

Procedure

➊

Attach a head cap.

Fit the head cap into place on the tip of the

head. The head cap is attached correctly when

its tab clicks into place in the hole in the head.

☞ P. 27, "Head Caps"

➋

Loosen the knob.

➌

Affix the adhesive sheet to the table,

then mount the material on the sheet.

Press down lightly on the material to secure

it in place.

If you’re performing printing with the head cap attached, this completes loading of the material.

If you’re performing printing with no head cap attached, then go on to the following steps.

Mounting the Adhesive Sheet

➢ Place it straight, aligned with the scale marks on the table.

➢ Place inside the table frame.

➢ Be careful not to allow any air bubbles to form between the adhesive

sheet and the table.

How to Place Material

Place the material at the center of the scale on the table.

Head cap

Center

line

Center line

Center of

the material

Table

Adhesive sheetMaterial

Adhesive

sheet

Material

Head cap

knob

Head Head

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 95 96

Keine Kommentare

Roland Metaza MPX-80 Bedienungsanleitung Seite 33