Roland PC-300 Bedienungsanleitung PDF herunterladen (Seite 13)

Setting the MIDI transmit

channel

To control the sound module, set the

PC-300’s MIDI channel to the same chan-

nel on which the module is receiving. If

the sound module is multitimbral, set the

channel on the PC-300 so it matches the

MIDI channel of the module’s Part that

you wish to control.

[Procedure]

1.

Press MIDI/SELECT [3] (the LED will

light).

2.

Select the MIDI channel by pressing

one of the MIDI CHANNELS keys [6].

3.

Press MIDI/SELECT [3] again (the LED

will go out).

Selecting sounds

Program Change/Bank Select messages are

used for changing Tones for an instrument

Part, and for changing Drum Sets for the

Drum Part (MIDI channel 10).

Changing sounds in a GS sound module

To change Tones in a GS module, you

need to send Bank Select messages using

control changes CC00 (called “H” here)

and CC32 (called “L”), followed by the

desired Program Number (PC).

The desired sound bank needs to be speci-

fied using both an “H” and an “L” value.

Be aware that only sending these two mes-

sages is not enough for selecting another

sound. You also need to transmit a

Program Change number.

On the PC-300, these three messages are

always sent as one set:

• Value of control change CC00 (“H”);

• Value of control change CC32 (“L”);

• Program Number.

Note: You can refer to the GS/GM sound

group list printed on the upper-right part of

the PC-300’s panel when specifying a Program

Number. See also the manual of the module

your are using.

[Procedure]

1.

Set the MIDI transmit channel to

match that of the Part or module you

wish to control.

See “Setting the MIDI transmit channel”.

2.

Press MIDI/SELECT [3] (the LED will

light).

3.

Press the black G#4 key (“H”) [9].

4.

Set the “H” value (CC00) by pressing

the appropriate keys in the NUMERIC

ENTRY section [12].

For single-digit program numbers (1~9),

pressing the corresponding key is enough.

Note: Press the [CANCEL] key [13] to erase

these values and start again.

5.

Press ENTER [14].

6.

Press the black F#4 key (“L”) [9].

7.

Set the “L” value (CC32) by pressing the

appropriate keys in the NUMERIC

ENTRY section [12].

For single-digit program numbers (1~9),

pressing the corresponding key is enough.

8.

Press ENTER [14].

9.

Press the black A#4 key (“Program

Change”) [10].

10.

Select the program number by press-

ing the appropriate keys in the NUMERIC

ENTRY section [12].

11.

Press ENTER [14].

12.

Press MIDI/SELECT [3] again (the

LED will go out).

11

Owner’s Manual

ENGLISH

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 127 128

Kommentare zu diesen Handbüchern

Keine Kommentare