Roland AXIS-1 Bedienungsanleitung PDF herunterladen (Seite 30)

A Method for Reducing Errors in Cutting Accuracy

Misalignment of the Y-axis and Z-axis origin points van affect finished results. Refer to "Part 5 Offset Adjustment for the Y-axis and

Z-axis Origin Points" and carry out adjustments.

Displacement of the Z-axis origin point in the positive direction can have a large effect on the finished results. This is because the side of

the tool (the outer peripheral tool) is prone to striking the first and second surfaces during thick finishing and prone to striking the third

and fourth surfaces during cutting.

If the finished results are poor even when you have made the value for [Four-surface cutting offset] in MODELA Player larger, then try

setting [Center-Z Offset] to a value that is more negative than the optimal setting. Note, however, that this produces finished results that

are correspondingly smaller.

It's important not to make the amount of tool extension longer than necessary. MODELA Player may not be able to correct for tool wobble

if such wobble becomes large.

It's also very important to keep the workpiece from bending or twisting during cutting. Give careful thought to how you load and support

the workpiece.

Part 6 Cutting Using MODELA Player

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Keine Kommentare

Roland AXIS-1 Bedienungsanleitung Seite 30