Roland FJ-42 Bedienungsanleitung PDF herunterladen (Seite 59)

4 User's Reference

4-6 What to Do If...

What to Do If...

If the FJ-52/42 doesn't run...

Is the power cord connected correctly?

Connect the power cord included with the FJ-52/42 to the unit, and plug the other end securely into an electrical outlet. (See “1-3 Setting

Up and Connection” .)

Is the FJ-52/42 power on?

Turn on the power. (See “2-3 Powerup” .)

Has material been loaded (the SETUP LED is lit)?

If the SETUP LED is not illuminated, make sure the material is loaded correctly and press the [SETUP] key to illuminate the SETUP

LED.

Is the PAUSE LED illuminated?

If the [PAUSE] key has been pressed and the PAUSE LED is lighted, the unit has been paused.

To resume printing or cutting, press the [PAUSE] key again. The PAUSE LED is extinguished, and printing or cutting resumes.

To terminate printing or cutting, first stop the transmission of printing or cutting instructions from the computer to the FJ-52/42. Then

press the [SETUP] key. Hold down for about 1 second. This deletes the printing or cutting instructions that have already been sent from

the computer to the FJ-52/42, and printing or cutting is stopped.

Is the top menu displayed?

If the top menu isn't displayed, printing doesn't start even when data is sent from the computer.

Conditions for starting printing

The material must be already set up (with the SETUP LED lighted),

and the display must show the top menu.

If another menu screen is displayed, press the [SETUP] key to go back to the top menu.

(Pressing the [SETUP] key when another menu screen is displayed does not cancel the set-up for the material.)

Are the computer and the FJ-52/42 linked with the right cable ?

The type of cable you need is determined by your computer. One which you are sure matches the model of computer being used should

be select.

Is the cable making a secure connection?

Connect securely. (See “1-3 Setting Up and Connection” .)

Has the correct driver selection been made for the application software?

Select the appropriate FJ-52/42 driver.

W 1234 mm

FINE BI-DIR

Top menu

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 68 69

Keine Kommentare

Roland FJ-42 Bedienungsanleitung Seite 59