Roland SOLJET SC-500 Bedienungsanleitung PDF herunterladen (Seite 18)

Mimaki CG-75 FX, CG-130 FX, CG-160 FX Cutters

To cut a contour using the Mimaki CG-75 FX, CG-130 FX, or

CG-160 FX cutters:

1. If you are connecting to your cutter via USB, install the

Mimaki USB driver.

2. Add a setup for the cutter to PhotoPRINT or Production

Manager.

3. Depending on the application, do the following:

• In PhotoPRINT, add the job and open Job Properties.

• In Flexi, design the job and open the RIP and Print

dialog.

4. Set Registration Mark to Mimaki Type 1.

5. Print the job and load the printed output into the cutter.

6. Send the cut job.

7. Configure the cutter:

a. If the LCD on the cutter reads REMOTE, press the

REMOTE button on the cutter to switch it to local

operation.

b. Turn off automatic mark detection:

i. Press the FUNCTION button on the cutter.

ii. Use the up and down arrow buttons to select Set

Up.

SET UP <ENT>

iii. Press the ENTER/HOLD button.

iv. Use the up and down arrow buttons to select

MARK DETECT.

MARK DETECT <ENT>

v. Press the ENTER/HOLD button.

vi. Use the up and down arrow buttons to select OFF.

MARK DETECT: OFF

vii. Press the ENTER/HOLD button.

viii. Press END to back out of the menus.

c. Set the origin at the intersection of the lower right mark:

i. Use the arrow keys to move the cutter head over

the corner of the lower right registration mark.

ii. Press the ENTER/HOLD button.

d. Set the cutter to Remote mode. Pressing the REMOTE

button on the cutter toggles Remote mode on and off.

8. Click OK in the software.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Keine Kommentare

Roland SOLJET SC-500 Bedienungsanleitung Seite 18