04232178 ’06-4-2N *04232178- 02* Owner’s Manual Thank you, and congratulations on your choice of the Roland RT-10 series. 201a Before using
10 Setting Trigger Parameters in a Percussion Sound Module retriggering, it then becomes easy for sounds to be omitted when the drums played fast (ro
11 Troubleshooting Normally, you should not have any problems if you have read this manual carefully, followed the instructions and have carefully ta
12 Troubleshooting • Is the volume too loud of nearby monitor speakers?• If in a band situation, is the bass amp too close or too loud?• Adjust the “
13 Specifications RT-10K (Kick Trigger) Trigger: 1 (Head)Connector: Trigger Output Jack (1/4 inch Phone Type)Dimensions: approx. 40 (W) x 110 (D) x 7
14 Percussion Sound Module Parameter Settings Following you will find specific parameter settings for the indicated percussion sound modules. These a
15 Percussion Sound Module Parameter Settings RT-10S Snare Trigger Dual Trigger Compatible Inputs SNARE RT-10S Snare Trigger Dual Trigger Compatible
16 Percussion Sound Module Parameter Settings RT-10S Snare Trigger Dual Trigger Compatible Inputs 1, 2 RT-10S Snare Trigger Dual Trigger Compatible I
RT-10KST_e.fm 17 ページ 2006年3月30日 木曜日 午後1時55分
As of April 1, 2006 (ROLAND)InformationWhen you need repair service, call your nearest Roland Service Center or authorized Rolanddistributor in you
2 USING THE UNIT SAFELY 001 • Before using this unit, make sure to read the instructions below, and the Owner’s Manual...
3 IMPORTANT NOTES 291a In addition to the items listed under “USING THE UNIT SAFELY” on page 2, please read and observe the following: Placement 354a
4 Before You Start • Drum trigger• Connection cable• Owner’s Manual (this manual)• Two hoop guards (RT-10K only)• Works perfectly with Roland V-Drums
5 Before You Start A drum trigger uses a built-in sensor to sense the timing and velocity (force) of how the drum is played. Then these trigger signa
6 Mounting The Drum Trigger • Set up your drums, making sure that any trigger-mounted drum is NOT in contact with another drum or stand. Vibrations t
7 Mounting The Drum Trigger fig.RT-10K-toritsuke 1. Attach the included hoop guards (2) to the inner and outer sides of the kick drum hoop.• Attach t
8 Mounting The Drum Trigger Set the sensor bolt so that the sensor compresses approximately 2–3 mm when pressed against the head. * The position of
9 Setting Trigger Parameters in a Percussion Sound Module Correct trigger type and parameter settings provide accurate triggering. We have included a
Kommentare zu diesen Handbüchern