Roland INTEGRA-7 Editor Bedienungsanleitung PDF herunterladen (Seite 6)

Installation and Setup (Mac OS)

Installation Procedure

Use the following procedure to install INTEGRA-7 Editor Ver.2.

NOTE

INTEGRA-7 Editor Ver.2 is a 64-bit plug-in.

It will not work with a 32-bit DAW or with a DAW that was started in 32-bit mode.

In order to use INTEGRA-7 Editor Ver.2, you must install the USB driver. Download the USB

driver from the Roland website. For details, refer to Readme.htm found in the le that you

download.&http://www.roland.com/support/

In order to use INTEGRA-7 Editor Ver.2, you must set the INTEGRA-7’s own USB driver setting

to “VENDER.” Make this setting as described in “Using the INTEGRA-7 with a Computer” in the

INTEGRA-7 owner’s manual.

1. Download the INTEGRA-7 Editor Ver.2 installer from the Roland website.

2. Decompress the le that you downloaded, and run “Integra7EditorV2_

Installer.pkg.”

3. The “Welcome to the INTEGRA-7 Editor Ver.2 Installer” dialog box appears.

Click [Continue].

If a screen asks you to select the install destination, click the drive on which

the system is installed, and then click [Continue].

4. The available installation types are shown.

Click [Install] or [Upgrade].

If the screen asks for authentication, enter your password and click [Install

Software].

5. The “The installation was completed successfully” dialog box appears.

Click [Close] to complete the installation.

Uninstallation Procedure

INTEGRA-7 Editor Ver.2 is installed in the following locations.

AU version: [Library] - [Audio] - [Plug-Ins] - [Components]

VST version: [Library] - [Audio] - [Plug-Ins] - [VST3] - [Roland]

To uninstall the AU version, delete “INTEGRA7EditorV2.component.”

To uninstall the VST version, delete “INTEGRA7EditorV2.vst3.”

1 2 3 4 5 6 7 8 9

Keine Kommentare

Roland INTEGRA-7 Editor Bedienungsanleitung Seite 6