Roland VS-1680 Bedienungsanleitung Seite 8

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 136
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 7
When synchronizing using a MIDI
sequencer as the master, the VS-1680
does not respond to the sequencer
messages
The MIDI cable is not connected correctly.
The MIDI cable is broken.
You are trying to synchronize using the MIDI clock.
The VS-1680 cannot be run in slave mode using a
method other than MTC.
The EXT indicator is off (“Sync Source” is set to
“INT”).
The two devices are not set to the same type of MTC
(during MTC synchronization).
The settings of the MIDI sequencer are not correct.
The MIDI sequencer is not in playback standby
mode (with the PLAY indicator blinking).
MTC reception is in poor condition.
Setting the Sync Error Level to “5” or higher may
improve conditions.
With a video device as the master, the
VS-1680 does not respond
The cable connected to the L-connector or the MIDI
cable is not properly connected.
The MIDI cable is broken.
The EXT indicator is off (“Sync Source” is set to
“INT”).
“SysEX.Rx.” (System Exclusive Receive Switch) is
not set to “On.”
“MMC” (MMC mode) is not set to “SLAVE.”
The MTC frame rate of the video device differs from
that of the SI-80S (Roland Video MIDI Sync
Interface), or the video and the VS-1680 are not set to
the same type of MTC.
MTC reception is in poor condition.
Setting the Sync Error Level to “5” or higher may
improve conditions.
Other problems
Data on the disk drive was not saved
properly
The VS-1680’s power was turned off without perform-
ing the shutdown process.
The power was turned off while the disk drive was
operating.
A strong shock was applied to the disk drive.
The disk drive or SCSI cable was connected or dis-
connected while the power was still turned on.
Reinitialize the disk drive (and also execute physical
formatting) (Owner’s Manual p. 111). Also, we rec-
ommend that you execute Surface Scan as well
(Owner’s Manual p. 113).
Troubleshooting
8
Seitenansicht 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 135 136

Kommentare zu diesen Handbüchern

Keine Kommentare