Roland VS-1680 Bedienungshandbuch PDF herunterladen (Seite 14)

New effects algorithms

BCut (Bass-cut filter)

This removes unwanted low-frequency components, such as

pop noise.

Sw (Switch) Off, On

Turns the bass-cut filter on/off.

Freq (Frequency) Thru, 20–2,000Hz

Adjusts the cutoff frequency of the bass-cut filter.

Enh (Enhancer)

This effect adds a phase-shifted signal to the original signal,

enhancing the presence of the sound, and bringing it to the

foreground.

Sw (Switch) Off, On

Turns the enhancer on/off.

Sens (Sensitivity) 0–100

Adjusts the degree to which the enhancer will respond to the

volume of the input signal.

Freq (Frequency) 1.0–10.0kHz

Adjusts the frequency at which the enhancer will begin to

take effect. The effect is applied at frequencies above the

specified value.

MixLvl (Mix level) -24–+12dB

Adjusts the amount of effect sound that will be added to the

original sound.

In (Input)

The input signal is divided into three parts by frequency

band.

InputG (Input gain) -24–+12dB

Adjusts the overall volume level of the signal before it enters

the expander (Exp) and compressor (Cmp).

D-Time (Detect time) 0–10ms

If the original signal is slightly delayed before being input,

the expander/compressor will be able to use more

processing time, and can adjust the level more appropriately.

Adjusts the time by which the original signal is delayed.

The output signal from the Mastering Tool Kit is delayed by

the time set here.

L-SplitP (Low split point) 20–800Hz

H-SplitP (High split point) 1.6–16kHz

Specify the frequencies at which the original signal will be

split into three parts.

fig.3-04

Exp (Expander)

This effect restricts the output by a specific ratio when low-

level signals are input.

fig.3-05

Sw (Switch) Off, On

Turns the expander on/off.

Low Thre (Low threshold) -80–0dB

Mid Thre (Middle threshold) -80–0dB

High Thre (High threshold) -80–0dB

Specify the level at which the expander will begin to take

effect.

Low Ratio 1:1–1:16, 1:INF

Mid Ratio 1:1–1:16, 1:INF

High Ratio 1:1–1:16, 1:INF

Adjust the ratio by which the output is restricted when the

input level is below the threshold level.

Low Atck (Low attack) 0–100ms

Mid Atck (Middle attack) 0–100ms

High Atck (High attack) 0–100ms

Adjust the time from when the input level falls below the

threshold level until the expander begins to take effect.

Low Rel (Low release) 50–5,000ms

Mid Rel (Middle release) 50–5,000ms

High Rel (High release) 50–5,000ms

Adjust the time from when the input level exceeds the

threshold level until the expander effect is bypassed.

Freq

L-SplitP H-SplitPLevel

Low Mid High

ThresholdOut

In1:1

Ratio

1:2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare

Roland VS-1680 Bedienungshandbuch Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Musikinstrumente Roland VS-1680