Roland DIF-AT24 Bedienungsanleitung

Owner’s Manual The DIF-AT24 lets you transfer up to 8 channels of 24-bit digital audio data between an R-BUS device and a device equipped with an ADA

10Connections and settingsConnectionexample 2Connecting the VS-2400CD and a computerHere's an example of synchronization with computer-based sequ

11Connections and settings Sampling Frequency settingsSet the sampling frequency of your sequencer software and the VS-2400CD to the same setting (44

12Connections and settingsConnectionexample 3Connecting the VS-2400CD and an ADAT deviceThis example allows digital audio signals to be transferred. M

13Connections and settingsConnectionexample 4Connecting the VS-2400CD with an ADAT device and BRCThe BRC is used to operate the VS-2400CD and ADAT dev

14Connections and settings Sampling Frequency settingsSet the sampling frequency of the VS-2400CD and ADAT device to the same setting (48 kHz). Mast

15Connections and settingsConnectionexample 5Using the DIF-AT24 as an additional MIDI OUT for the MV-8000Make connections as shown in the diagram.To p

03454012 ’03-11-1KSThis owner’s manual is printed on recycled paper.InformationWhen you need repair service, call your nearest Roland Service

03564056 ’03-11-1KSVM-7100/7200 と接続する場合VM-7100/7200 のシステム・バージョンが 1.7 未満の場合、DIF-AT24 は正常に動作しません。以下の方法で VM-7100/7200 のバージョンを確認し、必ず 1.7 以降にバージ

2 USING THE UNIT SAFELY 001 • Before using this unit, make sure to read the instructions below, and the Owner’s Manual...

3 104 • Try to prevent cords and cables from becoming entangled. Also, all cords and cables should be placed so they are out of the reach of children

4 IMPORTANT NOTES In addition to the items listed under “USING THE UNIT SAFELY” on page 2, please read and observe the following: 291a Power Supply 3

5 Contents Main Features...1USING

6 Panel descriptions Front Panel ADAT indicator This indicator will light green if an ADAT interface signal is being input to the ADAT digital IN con

7 Turning the power on/off Turning the power on Before you turn each device on, make sure that all devices are connected correctly.Once the connecti

8 Connections and settings Connectionexample 1 Connecting the VS-2400CD and a computer Here's an example of synchronization with computer-based

9 Connections and settings Sampling Frequency settings Set the sampling frequency of your sequencer software, the VS-2400CD, and the UA-1000 to the