Roland VR-3 Bedienungsanleitung PDF herunterladen (Seite 28)

Basic Operation

You can use the [MASTER] fader to adjust the volume level of the final output. Operate the fader while watching the [MASTER]

indicator.

1. Check the volume level of the final output.

See the [MASTER] indicator to check the volume level. If [OVER] lights up, the volume level may be excessive, resulting in

distortion. If only the indicators up to [-48] or [-30] light up, the volume level may be insufficient. This might worsen the signal-to-

noise ratio, resulting in poor-quality speaker output.

fig.master-meter.eps

2. Adjust the volume level.

Move the [MASTER] fader to adjust the volume level. A suitable level is where [-18] to [-6] light up at maximum input.

* If the volume level of speaker output is not suitable even after adjustment so that [-18] to [-6] light up, adjust the volume for the speakers or the

amplifier. Using the [MASTER] fader to carry out further adjustment might result in distortion or degradation of sound quality.

fig.master-fader.eps

3. Apply reverb.

Turn the [REVERB] dial to adjust the amount of reverb.

fig.adjust-reverb.eps

When reverb has been switched off via the menu, no reverb is applied regardless of where the dial is set. Go to the [AUDIO] menu, and at

[REVERB], set [REVERB SW] to [ON]. Refer to “AUDIO Menu” (p. 46).

Excessive reverb may cause feedback/howling to the final output.

Using the menus (p. 44), you can adjust the amount of reverb on each channel individually. Go to the [AUDIO] menu and use [REVERB SEND] to

adjust the amount of reverb. Refer to “AUDIO Menu” (p. 46).

Adjusting the Final Audio Output

Too high (red)

Appropriate (orange)

Too low (green)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Roland VR-3 Bedienungsanleitung Seite 28

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DJ-Controller Roland VR-3