Roland AXIS-1 Bedienungsanleitung PDF herunterladen (Seite 26)

Chapter 3 Operation

3-1 Getting Ready for Cutting Using the Rotary Axis

Dimensions of Workpieces Installable and Start Location

Dimensions of Workpieces Installable

Example : Loading a Square Block

A workpiece that fits within the range of a 42.5 mm radius from the center of the rotary axis by 135 mm long can be

loaded.

The figure shows the maximum size when loading a workpiece that is 40 mm thick.

➢ Maximum width when loading a workpiece measuring 40 mm thick : 75 mm

(The maximum width varies according to the thickness of the workpiece.)

➢ Workpiece thickness that can be held by the workpiece chuck : 12 to 40 mm

➢ Loadable workpiece length : Maximum 135 mm

The Locations of the Origin Points

When you perform cutting using the rotary axis, you make the respective settings for the X-axis, Y-axis, Z-axis, and A-

axis origin points. The X-axis origin becomes the start location for cutting. Make the setting to match the workpiece, so

that the workpiece does not strike the rotary axis unit during cutting. Align the Y and Z origins with the center of the

rotary axis. The Z-axis origin is to be set so as to match the length of the tool. Set the A-axis origin when you want to

specify the start location for the direction of rotation.

To perform cutting using the rotary axis, you need to set the Y-axis origin at the center of rotation. Be sure to make this

setting when you install the rotary axis unit for the first time, and whenever you reinstall it. Make the setting again

whenever displacement of the Y origin becomes a concern during continuous use.

☞ P.13 "Setting the Y-axis Origin Point for the Center of Rotation"

75 mm

Maximum 135 mm

40 mm

Objects that fit within the range of a 42.5 mm

radius from the center of the rotary axis

75 mm

Center of the rotary axis

Workpiece

40 mm

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 51 52

Keine Kommentare

Roland AXIS-1 Bedienungsanleitung Seite 26