Roland Octa-Capture Bedienungsanleitung PDF herunterladen (Seite 3)

Checking the Version

Please check the OCTA-CAPTURE’s system software version.

When you turn the power on, the system software version is shown in the lower middle of the screen.

If a version earlier than V1.50 is indicated

An update is required. Please perform the update as described below.

If V1.50 or later is indicated

No update is required.

Updating

1. Disconnect the USB cable.

2. While simultaneously holding down the [

] button in the OCTA-CAPTURE’s PRE-AMP control section and pressing the

[CURSOR/VALUE] knob, turn the power on.

Continue holding down the button and the knob until the following screen appears.

3. Use the USB cable to connect the OCTA-CAPTURE to your computer.

When the USB connection is detected, the following screen will appear.

Your computer will recognize the OCTA-CAPTURE as a removable disk.

4. Drag (copy) UpdOcta.dat onto the removable disk.

5. When you see that the copy has been completed, disconnect the USB cable.

After you disconnect the USB cable, the program will start being written.

NOTE

Do not power o the OCTA-CAPTURE until the update is complete, doing so may damage the unit.

A screen like the following will appear.

When the program has been updated successfully, the screen will show the updated version.

This completes the update procedure.

Updating the System Program

1 2 3 4 5 6 7 8 ... 22 23

Keine Kommentare

Roland Octa-Capture Bedienungsanleitung Seite 3