2-1
Part 2 Performing Cutting
Place the material against the pinch rollers.
Load the material as shown in the figure, so that it does
not come loose during cutting.
1
Turn the sheet feed knob to align the forward edge of the
material with the back of the blade protector.
2
Part 2 Performing Cutting
2.1 Load the Material
Make sure the two sides of the material are even.
Pinch rollers
Sheet feed knob
Blade protector
Do not use any of the following materials. The material may come loose during cutting or otherwise fail to be fed
properly.
Materials which has
curled upward
Material with a front
edge that is not
straight
Material that is
longer than 1110 mm
(43-1/4 in.)
Material with left and
right edges that are
not parallel
Kommentare zu diesen Handbüchern