Roland BR-900CD Bedienungshandbuch PDF herunterladen (Seite 115)

115

Fixing the Pitch of Vocals (Pitch Correction)

Section 3

Setting the Correction Method for

Vocal Pitch (Pitch Correction Edit)

Each of the preset patches 1 through 5 uses a slightly

different method for correcting pitches. Normally, it will be

sufficient to select the patch that gives the results you like

best; however, if you cannot achieve favorable results using

any of these patches, you can change the Pitch Correction

settings to create a patch of your own.

1. Select a preset patch to base your new patch on.

2. Press CURSOR [ ] [ ] to move the cursor to “EDIT,”

and press [ENTER].

The Pitch Correction edit screen will appear.

3. Use [CURSOR] to move the cursor to the setting you

want to change and select a new value using the TIME/

VALUE dial.

fig.35-05d

Type LO.MALE, HI.MALE, LO.FEML, HI.FEML

Set this parameter to match the type of voice in the original

vocal part. If this parameter is not set correctly, problems will be

more likely to occur in pitch detection and correction.

LO.MALE (Low Male)

Select this setting for a low-pitched, male voice.

HI.MALE (High Male)

Select this setting for a high-pitched, male voice.

LO.FEML (Low Female)

Select this setting for a low-pitched, female voice.

HI.FEML (High Female)

Select this setting for a high-pitched, female voice.

* If the BR-900CD is frequently incorrect when detecting the

pitch, either change the type setting. In certain cases, this will

reduce the number of incorrect detections.

Smooth 0–100

This setting determines how quickly pitch correction will react

to changes of pitch in the original vocal part. Large values result

in a longer time before correction is applied; consequently,

changes in pitch will be more gradual. Small values produce

rapid changes in pitch.

Corrections that are made too rapidly seem robotic.

However, if the correction is too smooth, in some cases it may

appear as if no correction has been applied. For natural

sounding pitch corrections, set the value in a range between 20

and 40.

4. Press [EXIT].

The Pitch Correction’s patch selection screen will appear.

fig.35-06d

5. To save your modified settings, carry out the procedure

described in “Saving the Pitch Correction Settings

(Write)” below.

Saving the Pitch Correction

Settings (Write)

Modified Pitch Correction settings are saved by writing them

together under a new patch name.

* You cannot write patches while songs are being recorded or

played back.

* If you do not need to change patch name, go to step 4.

1. At the Pitch Correction patch selection screen, press

CURSOR [ ] to move the cursor to “NAME,” and

press [ENTER].

The Patch Name Setting screen appears.

fig.35-11d

2. Use CURSOR [ ] [ ] and the TIME/VALUE dial to

enter the patch name.

* Press [ENTER] to switch between uppercase and lowercase.

3. After you have completed entering the effect settings

and patch name as desired, press [EXIT] to return to the

Patch selection screen.

4. Press CURSOR [ ] [ ] to move the cursor to

“WRITE,” and press [ENTER].

The Write screen appears.

fig.35-12d

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 231 232

Kommentare zu diesen Handbüchern

Keine Kommentare

Roland BR-900CD Bedienungshandbuch Seite 115

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Musikinstrumente Roland BR-900CD