Roland FC-300 Bedienungshandbuch PDF herunterladen (Seite 48)

Other Features

Press PARAMETER [ ] [ ] to select “SYS:Bnk Chg Mode.”

Press the VALUE [ ] [ ] to program the settings.

Here are some examples of operation in Standard Mode.

When you’ve finished making the settings, press [UTILITY] or [EXIT].

You can set an upper limit on the banks that can be switched, thus limiting the range

of banks that are switched and allowing you to select only the patches required.

Press PARAMETER [ ] [ ] to select “SYS:Bank Extent.”

Press VALUE [ ] [ ] to set the upper limit on the banks.

When you’ve finished making the settings, press [UTILITY] or [EXIT].

Using the [ ] [ ] Pedals to Make the Settings

Value

Explanation

IMMEDIATE

Program changes are transmitted immediately when [ ] or

[ ] is pressed.

Example) When starting from “003,” pressing [ ] simulta-

neously transmits PC#8.

WAIT FOR A NUM Program changes are transmitted when a number pedal is

pressed after [ ] or [ ] is pressed.

Example) Starting from “003,” after [ ] is pressed and all of the

green number pedal indicators are flashing, pressing number

pedal 8 outputs PC#8.

RESET NUMBER Although program changes are transmitted immediately when

[ ] or [ ] is pressed, just as with Immediate, in this case, the

number furthest to the left is output.

Example) If starting from “003,” pressing [ ] simultaneously

transmits PC#6.

Limiting the Range of Banks That Can Be Switched

(Bank Extent)

This is enabled only when PC

Mode is set to EFFECTS.

FC-300_e2.book 48 ページ２００７年１０月４日　木曜日　午後５時２２分

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 71 72

Keine Kommentare

Roland FC-300 Bedienungshandbuch Seite 48